: After the reload, verify the image version and ensure the web directory is populated by checking dir flash: . AP Conversion using MODE Button | mrn-cciew
Use this if the AP is stuck in a boot loop or you cannot access the CLI. Ap3g2-k9w7-tar.153-3.jf15.tar
Log into the AP via SSH or Console cable. Enter privileged EXEC mode and run the following command: : After the reload, verify the image version
This technical paper provides an overview of the firmware, a critical system image for Cisco 2702 and 3700 series Access Points (APs). It details the image composition, common deployment challenges—including the "404 Not Found" bug—and the procedural requirements for a successful installation. Technical Overview: Cisco Autonomous AP Image (15.3.3-JF15) 1. Image Identification and Purpose Enter privileged EXEC mode and run the following
If the AP boots into the standard IOS prompt:
.jpg)
