The output of the CHE100-0R7G-S2 is three-phase 220V . It is designed to control a three-phase induction motor, not a single-phase motor. Attempting to run a single-phase motor without derating will damage the drive.
PRG/ESC (Enter/Exit menu), DATA/ENT (Confirm), RUN/STOP (Start/Stop), UP/DOWN (Parameter change/Frequency adjust). 4. Basic Function Parameter Settings P0.01: Control Mode ( P0.03: Max Frequency ( P0.04: Upper Frequency Limit. P0.07: Command Source ( : Terminal, : Communication). P0.11/P0.12: Acceleration/Deceleration time. P0.15: Terminal Jog. P1.00: Motor Rated Power. P1.01: Motor Rated Frequency. 5. Troubleshooting (Fault Codes) invt che100-0r7g-s2 manual
: Features an RS-485 communication interface with standard Modbus protocol. The output of the CHE100-0R7G-S2 is three-phase 220V
You can find the full documentation on these reputable platforms: ManualsLib - Operation Manual (124 pages) INVT Official Download Center Scribd - CHE100 User Manual PDF P0.07: Command Source ( : Terminal
October 2025 Document version: 2.0 – Companion guide for INVT CHE100-0R7G-S2 manual (v1.8 and above) Copyright notice: INVT trademarks belong to INVT Electric. This guide is for educational and operational support purposes only. Always refer to the original manual for safety-critical information.
High Voltage Warning: After powering off the drive, wait at least 5 minutes for the DC bus capacitors to discharge before touching any terminals.No Capacitors: Never connect capacitors or surge absorbers to the output (U, V, W) terminals.Phase Insulation: Before connecting the motor, use a megohmmeter to ensure the motor phase-to-ground insulation is intact.
