Fanuc 11m Parameter List

| Parameter # | Description | | :--- | :--- | | | Rapid Traverse Rate (Rapid Feed) . Sets the maximum rapid speed for X, Y, Z axes respectively (units: mm/min or inch/min). | | 0710 - 0712 | Reference Point Return Direction . 0 = Positive direction (+), 1 = Negative direction (-). | | 0720 - 0722 | Stored Stroke Limit 1 (Soft Limits) . Sets the positive travel limit (software overtravel) for X, Y, Z. | | 0730 - 0732 | Stored Stroke Limit 2 . Sets the negative travel limit for X, Y, Z. | | 0760 - 0762 | Backlash Compensation . Compensation value for screw backlash (usually in units of 0.001mm). |

alarm; this is normal and indicates write access is enabled. Access Parameters : Press the soft key, then the soft key to view and edit the main parameter list. Restore PWE : After changes, set Parameter 8000 Squarespace Communication Parameters (RS-232/I/O) These are typically found starting at Parameter 5110 for Reader/Puncher interface settings: Squarespace Device Type (Specifies reader/puncher specifications, e.g., for standard control codes). (Usually set to for Fanuc controls). (Values correspond to specific speeds: for 9600). Squarespace Critical System Parameters 2nd Reference Point (Coordinate value in machine coordinates). 3rd Reference Point Rapid Traverse Rate for each axis. Backlash Compensation (Slow/general compensation). Rapid Backlash Compensation Spindle Orientation position adjustment. 6700#0 (PCM) Part Counting : Specify custom for part counting (if Option Parameters (9000 Series) Fanuc 10M-11M Communications Parameters - Squarespace | Parameter # | Description | | :---

When your Fanuc 11M alarms, the parameter list is often the cure. 0 = Positive direction (+), 1 = Negative direction (-)

: Part counting logic (0 = count on M30/M02; 1 = count on custom M-code). Option Parameters (9000 Series)