To connect a single-level foot switch, you typically use a jumper wire (min 24 AWG) between screw #11 and screw #10 on the back terminal block. The manual details binary combinations of these screws to select different weld schedules.
: Always use a continuity checker to identify the wires for each level before connecting. If you are looking for specific troubleshooting codes programming steps weltouch cy-210b manual
You just watered, and the meter says "Wet." No kidding. Wait 30-45 minutes for the water to distribute evenly through the soil before testing. To connect a single-level foot switch, you typically
), the CY-210B is designed to provide high precision in resistance welding by examining each half-cycle of weld current flow to compensate for changes in real-time. Core Features of the Weltouch CY-210B To connect a single-level foot switch